Anti rust primer - epoxy primer 750 ml

Epoxy Anti-corrosion primer A+B 750 ML


In stock

Is a high-quality 2-component solvent-free epoxy primer based on amine. The hardened layer has a very high resistance and is a good barrier against water. The hardened layer does not allow water (vapour) to pass through. Available in 750 ml and 7.50 lt packages.

€43.94 / set



The product is applied on hard surfaces as a protective layer against water, on polyester as an osmosis prevention and on metal as a protection against rust.


Depending on the surface and quality, sandblast or sandpaper. The surface must be clean, dry and grease-free. Only use from 15°C. Mix both components in a 4/1 volume ratio and process within 2-3 hours. Apply with roller or brush. Hand-dry after 5 hours at 20°C. Sandable after 24 hours. Cured after 7 days. Can be repainted after minimum 5 hours and maximum 30 days. Apply 2-4 layers for an optimal sealing. If Seaguard fouling stop is applied afterwards, apply a layer of Light Primer first. Before launching, the ANTICORROSION PRIMER should be left to harden for at least 7 days (20°C).
  • Irritating to eyes. 
  • Always wear suitable protective clothing and gloves. 
  • Wearing a carbon filter mask is recommended. 
  • Keep out of reach of children. 
  • In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. 
  • If swallowed, seek medical advice immediately and show this container or label. 
  • Not for large surface areas and living quarters. 
  • Cleaning agent for tools: epoxy thinner or cleaner M (environmentally friendly substitute for acetone).

Technical specifications

Download technical fiche