Universal 2K epoxy primer - anti corrosion and anti osmosis

Epoxy Anti-Osmosis & Corrosion Spray 400 ML


In stock

Is a high-quality 2-component epoxy primer on a polyamide basis. The hardened layer has a very high resistance and is a good barrier against water. The hardened layer does not let water (vapour) pass through. Does not require sanding between coats.

Available in a handy 400 ml spray can.

€31.51 / st


The product is applied on hard surfaces as a protective layer against water, on polyester as an osmosis prevention and on metal as a protection against rust. Light Primer can also be applied on plywood, hardwood and aluminium. Is a good primer for lacquers and antifouling.


  • Depending on the surface and quality, sandblast or sandpaper. 
  • The surface must be clean, dry and grease-free. 
  • Process between 15°C and 25°C. and at a humidity of 40-50%. 
  • Shake the can for 2 minutes. 
  • Then remove the red button, turn the can 180° and press the red button in place. 
  • Press evenly on a flat surface until the red button is fully pressed. 
  • Then shake again for 2 minutes. (you should hear the metal balls). 
  • Adjust the nozzle so that you can spray the desired surface. 
  • Hold the can at a distance of 10 to 20 cm. 
  • Apply 2 coats in a layer thickness of 80-200 microns. 
  • For an anti-corrosion treatment, the minimum dry film thickness is 240 microns. 
  •  Wait approximately 10 minutes between coats. 
  • After spraying, turn the can around and clean the nozzle by briefly spraying. 
  • The processing time after mixing is about 48 hours at 20°C. 
  • Dust dry after 1.5 hours and hand dry after 3 to 5 hours. 
  • Full cure after 7 days.
  • Contains xylene (isomer mixture) and is flammable. 
  • It is harmful by inhalation and in contact with skin. 
  • Irritating to eyes. 
  • Always wear suitable protective clothing and gloves. 
  • It is recommended to wear a carbon filter mask. 
  • Keep out of reach of children. 
  • In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. 
  • If swallowed, seek medical advice immediately and show this container or label. 
  • Not for large surface areas and living quarters. 
  • Cleaning agent for tools: thinner for light primer or cleaner M (environmentally friendly substitute for acetone).

Technical specifications

Download technical fiche