Multi-purpose coating 1 kg

Flexovoss K6T A+B 1 KG


In stock

Is a 2-component solvent-free PU coating with tough elastic properties. Good electrical insulation and perfectly waterproof. Can be painted and glued with the traditional products. Can be applied with a brush or a spatula. K6T is temperature resistant up to 120°C (from 60%C, however, increasing softening may occur).

Available in 1, 5 and 30 kg packs.

€27.69 / set



As a protective coating for water tanks or reservoirs made of metal, lead, zinc. Flat roofs and sealing on foam boards or substrates made of metal and concrete.
Is thixotropic and ideal for vertical surfaces.

Can also be used as an adhesive for e.g. PVC and polystyrene foam without damaging the surface. Can be used in the food sector. Ideal as tile adhesive for applications in humid areas.


Always ensure that the surface is as dry and grease-free as possible. In case of porous substrates, first apply a layer of primer G4. Allow this to dry for at least 4 hours and no more than 8 hours. Then mix K6T and hardener in a 4/1 ratio by weight.

Potlife: approx. 30 min. at 20°C.
By means of 0.15% PUR accelerator, potlife is reduced to 15-20 min. at 20°C.
Processing temperature: 0-30°C. K6T is cured after 12 hours.
Fully cured after 1 week.

Potlife: ca. 30 min. bij 20°C
Door middel van 0,15% PUR-versneller, verkort de potlife tot 15-20 min. bij 20°C
Verwerkingstemp.: 0-30°C. K6T is uitgehard na 12 uren
Na 1 week volledig doorgehard.

Tip : can be poured and distributed with a toothed spatula, brush or roller (structure remains).

Attention : 
  • the larger the quantity you finish, the shorter the processing time.
  • Avoid the mixing of air, use our special screw mixer.
  • Too much humidity can cause air bubbles to form on the surface.
  • Always provide appropriate protective clothing and gloves. 
  • Avoid prolonged skin contact. 
  • Cleaning agent for tools: cleaner M (environmentally friendly substitute for acetone).

Technical specifications

Download technical fiche